Doepfer Dial Electronic User Manual download pdf (Page 11)

User's Guide Page 11 DIAL ELECTRONIC

Extent of delivery

The

delivery contains the following parts:

•

Dial Electronic pc board, assembled and tested

•

Power Supply (230V mains voltage, European type mains plug, output voltage

range 7...12V, current min. 100 mA) included only for shipments within Germany,

for shipments outside Germany please contact your local representative or dealer

•

Dial Electronic user's guide (i.e. the guide in your hand)

•

Pocket Dial user's guide

Rotary encoders, switches, LEDs and cables are not included but have to be added

by the customer. We offer a suitable control set (16 encoders with black knobs, 6

buttons, 4 LEDs, cables) that has to be purchased separately.

The DE control set contains the following parts:

•

16 rotary encoders (ALPS EC16B24)

•

16 black rotary knobs (same as used for Pocket Dial)

•

16 cable sets with female connectors for the encoders

•

6 momentary switches (round, with thread for mouting into a front panel)

•

one 16 pin ribbon cable with 16 pin female connector, about 30 cm (for wiring the

switches to JP1)

•

4 LEDs (red, 3 mm)

•

one 10 pin ribbon cable with 10 pin female connector, about 30 cm (for wiring the

LEDs to JP2)

Remark:

The measure of the 3 pin female connector of the cable sets is a little bit more than

the corresponding pin header on the pc board. Consequently the female connectors

have to be grinded off a bit (e.g. with sandpaper). Otherwise several female

connectors will not fit side by side.

1 2 ... 6 7 8 9 10 11 12

No comments

Doepfer Dial Electronic User Manual Page 11